First, pop the hood, and prop it up.


There are six screws holding the top of your factory grill securing it to the frame. Remove them. Then, slide the grill outwards away from your Ranger.


This is what your factory grill will look like. You will have to use a hacksaw to remove the top panel( you can skip this step if you have a polished steel top panel).


This is how your grill should look like now. The top panel should be detached from the rest of the grill.


You will have to drill holes in order to mount the lower brackets. Line up the lower bracket and determine where you will have to drill. Next, using a drill bit relatively close to the size of the provided bolts, drill straight down and through.


Mount the lower brackets using the holes you just drilled. There will be holes for the upper brackets, so drilling will not be necessary.


Line up the billet grill, there will be four holes (2 upper and 2 lower) line these holes up with the brackets. Using the provided bolts, bolt all four brackets to grill. Don’t forget to screw the top panel of your old grill back on.



This is what your grill will look like after installation. Enjoy!


This Page has had 1,158 views Since 4/22/09.