Materials/Tools:
- Philips screwdriver
- Drill with ¼” drill bit
- 10mm wrench
- Flathead screwdriver (optional)

Step 1:
Pop the hood and remove all the screws shown in the below picture with a Philips screwdriver.

Step 2:
Turn the wheel inwards so it’s out of the way. Pry the inner lining of the wheel well out and away from the front bumper to get to the screw holding the bumper to the fender. Remove this screw on both the driver and passenger sides of the car using a Philips screwdriver.

Step 3:
Remove the two bolts under the front of the bumper with a 10mm wrench. The bumper can now be pulled off.


Step 4:
Remove the Styrofoam.

Step 5:
Remove the single screw holding the corner lights in with a Philips screwdriver. Pull the corner light straight out and pull out the plug. A flat head screwdriver may be necessary in order to pinch the clip to remove the plug.

Step 6:
Line up the new aftermarket bumper and determine where you need to drill the holes to attach it to the fenders. Drill the holes using a ¼” drill bit. Holes will also need to be made to replace the screws under the hood (no picture available).

Step 7:
Mount the new bumper and replace the screw into the newly drilled holes.

Step 8:
Reverse step 5 to reinstall the corner lenses.

Step 9:
Note that with fibreglass bumpers, some modifying may be necessary in order for the kit to mount properly.


This Page has had 994 views Since 4/22/09.