Tools Needed:
-Electrician Tape
-Wire Strippers

Steps:

- After getting your new PlasmaGlow® neon license plate out of the casing, proceed to open the hatch (trunk) of the car.

-BUT, first always make sure you’ve unplugged your battery before performing electrical work on your car.

- There’s 2 large compartments that will give you access to the license plate lights (already on the car) that you will need to open first.

-Now first things first, lets run the wire through the slot for the license plate light, which can easily be popped off and placed back in.

- After opening it, go ahead and unplug the cord running to the light.

- You’ll then you proceed to strip the insulation from the wires and attach the red wire from the neon from to the black wire on that goes to the license plate light. The of course attach the black wire to the white wire that goes to the license plate light.

-Now is the part where that electrical tape comes in handy. You’ll want to protect the wires with the electrical tape so wrap them tight.

-Now, put the license plate light back in place by pulling it in from the inside, and then placing the spare wire into the compartment to conceal it, and close it up. The wire should be running out the license plate light’s area, and you can now put the screws in to attach it to the car.

-Congrats, the finished product should look like this.

-And now ladies and gentlemen, it’s time to let your glow show!


This Page has had 954 views Since 4/22/09.